Crochet Plush Shark Amigurumi Pattern With Grey Yarn

Kids can cuddle this crochet plush shark amigurumi at nap time or prop it on a nursery shelf, where its grey fins and cream belly suit an ocean room. Ocean birthday parties and baby showers both welcome a grey chenille shark plushie that rests flat on its belly without tipping.

Chenille sinks under your fingers as the Crochet Plush Shark Amigurumi grows round by round in your lap. Every fin you attach changes its face, so you keep squeezing it. Makers who like fuzzy yarn wait for the moment the eyes go in and the Crochet Plush Shark Amigurumi finally looks back.

Crochet Plush Shark Amigurumi

Starting at the back and finishing at the belly, every fin on this shark grows right out of the body rounds, so nothing needs sewing on. I used fluffy gray chenille for the top and switched to cream for the belly, which gives him that classic shark color split. Big glossy safety eyes sit right on the line where the colors meet. Between them, a small black smile curves up. Super bulky yarn makes this crochet plush shark amigurumi work up fast and turn out squishy enough to hug. Nine rounds and a few tiny fins are all it takes.

Quick Facts

  • Difficulty: easy, with one slightly tricky round where the side fins are worked into the front loops
  • Time: in my experience, about an hour from magic ring to finished face, possibly a little longer if chenille is new to you

Materials and Tools

  • Super bulky plush chenille yarn in gray for the top of the shark
  • Super bulky plush chenille yarn in cream for the belly
  • Crochet hook sized for your yarn, usually between 4.5 mm and 5.5 mm for plush yarn
  • Polyester fiberfill stuffing for toys
  • Two black safety eyes (the original pattern recommends 8 mm or 10 mm; mine are on the larger side)
  • Black embroidery thread for the smile, plus a little extra for eyebrows if you want them
  • Tapestry needle, scissors, and a stitch marker

Abbreviations (US Terms)

  • MR: magic ring
  • sc: single crochet
  • inc: increase, 2 single crochet in the same stitch
  • dec: decrease, an invisible decrease works best
  • FLO: front loop only
  • ch: chain
  • sl st: slip stitch
  • hdc: half double crochet
  • st(s): stitch(es)

Customization Ideas

  • Swap the gray for pale blue or soft pink, keeping the belly cream or white.
  • Add the black eyebrows from the original pattern for a grumpy, determined look.
  • Stitch the smile in red instead of black for a brighter face.
  • Stitch a small pink blush under each eye with a few strands of embroidery thread.
  • Make a family in different colors; the size changes with your yarn, so a lighter weight gives you a smaller baby shark.

The Pattern

The Body

  • Start with gray yarn.
  • Round 1: work 6 sc in a magic ring (6). This is the top of the shark's back.
  • Round 2: 6 inc (12). You have a small flat circle.
  • Round 3: [1 sc, 1 inc] 6 times (18). Chenille hides stitches easily, so keep your marker in place every round.
  • Round 4: [2 sc, 1 inc] 6 times (24). The circle reaches its full width.
  • Round 5: 24 sc (24). The edge starts turning down into the dome of the back.
  • Round 6 begins the side fins, worked as you go around the body.
  • Round 6: 5 sc.
  • Fin 1: in the FLO of the next stitch, sl st and ch 3.
  • Working back down the chain, make 1 sl st in the 2nd ch from the hook and 1 sc in the next ch.

  • Anchor the fin with 1 sc in the FLO of the next stitch on the body.
  • Continue with 10 sc.
  • Fin 2: in the FLO of the next stitch, sl st and ch 3.
  • Working back down the chain, make 1 sl st in the 2nd ch from the hook and 1 sc in the next ch.
  • Anchor the fin with 1 sc in the FLO of the next stitch on the body.
  • Finish the round with 5 sc.
  • Color change: on the final pull through of the last sc in Round 6, switch to cream. You should still have 24 base stitches, with two small gray fins sticking out on opposite sides; on my shark they puff up into soft rounded nubs at the sides, right above the belly line.
  • Round 7: in cream, work [2 sc, 1 dec] 6 times (18). When you reach the stitches where the fins were made, work into the unworked back loops so the fins keep popping outward; the cream belly now starts curving under.
  • Insert the safety eyes on the color change line between Rounds 6 and 7, spaced 4 stitches apart. On my shark they sit low on the face at the front, right where gray meets cream, with room for the smile between them.
  • Round 8: [1 sc, 1 dec] 6 times (12). The belly closes in and the shark takes on its round, flat bottomed shape.
  • Stuff the body firmly with fiberfill. Push the stuffing out toward the sides so the dome stays full and smooth under the chenille.
  • Round 9: 6 dec (6). Top up the stuffing first if the belly feels soft.
  • Finish off: cut the yarn, weave the tail through the front loops of the remaining 6 stitches, pull tight to close the hole, and hide the tail inside the body.

The Tail Fin

  • The tail is built right onto the back of the body at the color change point, which also hides the color change jog.
  • Using gray yarn, insert your hook at the color change point on the back of the shark and attach the yarn.
  • Lower tail lobe: ch 3, then starting in the 2nd chain from the hook, work 1 sl st and 1 sc.
  • Upper tail lobe: from the same base position, ch 4, then starting in the 2nd chain from the hook, work 1 sl st, 1 sc, and 1 hdc. On my shark the upper lobe comes out slightly larger and sits above the lower one, both puffing up into round bobbles.
  • Anchor the top of the tail by slip stitching into the body one stitch higher, into Round 5.
  • Fasten off and pull the yarn tails inside the body to hide them.

The Dorsal Fin

  • Using gray yarn, insert your hook into the top center of the shark's back, 1 stitch below the magic ring in Round 2, and attach the yarn.
  • Ch 4, then starting in the 2nd chain from the hook, work 1 sl st, 1 sc, and 1 hdc.
  • Anchor the fin by slip stitching into the center of the magic ring in Round 1. On my shark the dorsal fin stands up on top as a round puffy nub rather than a sharp point, which is just how chenille behaves at this size.
  • Fasten off and hide the yarn tails inside the body.

Facial Details

  • The smile: thread your tapestry needle with black embroidery thread and stitch a small curved smile directly between the eyes. On my shark it sits on the gray just above the cream belly line and curves gently upward at the ends; the original pattern uses a short straight red line instead.
  • Eyebrows (optional): with black embroidery thread, stitch a small slanted line above each eye, pointing diagonally inward and downward for an angry or determined look. My shark is shown without eyebrows for a softer face.
  • Tie the knots securely and bury the ends inside the plushie.

Tips

  1. Count your stitches by feel rather than by sight. Chenille hides the stitch tops, so run a finger along the edge or use a stitch marker every round, especially around the fins in Round 6.
  2. Double up the embroidery thread for the smile. A single strand sinks into the fluffy pile and nearly disappears.
  3. Fit the safety eye backs before stuffing and push them all the way on. Chenille is thick, and a loose back is the most common reason eyes wobble or pop out.

Yarn Substitution

The chunky, rounded look of the fins comes from super bulky chenille, so changing yarn changes the shape. With a worsted weight yarn and a smaller hook, the same counts give you a much smaller shark, and the fins come out sharper and more pointed. If you substitute, keep the fabric tight enough that no stuffing shows between stitches.

FAQ

Is this shark safe for babies?

Not as written. Safety eyes are a small part risk for babies and toddlers. For a child under three, skip the safety eyes and embroider the eyes with black yarn instead.

Why are my fins flat instead of popping out?

The fins only stand out if Round 6 goes into the front loops and Round 7 goes into the matching back loops. If you worked through both loops, the fins fold down against the body.

Do I really not need to sew anything?

The fins and tail are all crocheted straight onto the body, so there are no separate pieces to sew. The only needle work is closing the bottom and stitching the face.

How big is the finished shark?

Mine sits comfortably across both palms. The pattern does not give a finished size, and yours will depend on the yarn and hook you choose.

0 Shares

Leave a Reply

Your email address will not be published. Required fields are marked *